Tips To Unclog a Garbage Disposal With a Smart Garbage Disposal Guide

Even when you become careful about things you put into your garbage disposal, most likely you will face clogging. However, there are various simple things that you should do to keep ensure that clogging is at the minimum and also necessary steps that you can take when you find clogging occurring. Your garbage disposal is usually finicky, its therefore necessary for you to expect it that it will devour or even digest everything. There are waste materials that can’t be digested for example, you should not throw avocado pits, artichokes, fish bones, chicken bones or corn cobs into your disposal. The garbage disposal will clog. However, it’s essential to flip through the manual of the manufacturer to know about the disposal limitations.

When cleaning your disposal you need best garbage disposal reviews of the products so, you should never use the chemical drain cleaners. These chemicals become corrosive that cause damages to the plastic and rubber parts. There are deodorizers that are recommended for disposal. For example, you can use lemon. Cut it into half, you throw one half into your disposal and turn the unit on where you will allow it to run for one or two minutes. The lemon that you use will help in removing the residue building up in interior parts of the disposal and also deodorize the unit. You will know that the process is perfectly working because you will smell fresh lemon. If you find that the instructions given by the manual aren’t helpful, you can use these vital steps in unclogging garbage disposal:

Switch OFF Electrical Power

The garbage disposal switch is usually under the cabinet such that it’s close to the disposal. In case you don’t find it’s switch, turn off the breaker at the main power panel. You can also remove a fuse powering the disposal. Remember that you should not put your hands inside the disposal. Even though the switch might be defective and therefore you don’t have to put your hand inside the disposal.

Check The Disposal Inside

A flashlight might help to shed some light to help know the problem. Inside, you might see an object that has been caught. In case it’s an object that caused the stoppage, you can use pliers to remove the object. After removing the object, you can wait for some minutes for the disposal of motor cooling. Turn the power on and push it’s reset or even overload protector button. This button is usually at the top of your garbage disposal. If you will find that the disposal being clogged again, these steps will help:

Then the power off again and then insert a long dowel, a broom handle or wooden spoon. Remember that you should never put your hand inside that drain opening. When you do that, push at the bottom end of your wooden probe to be against the impeller. You can also rock it back and forth to ensure you free it. If the impeller will move freely, you have to wait for a few minutes to allow motor cooling. Then you will turn the power on and push it’s a reset button.